This is a tool holder for all the stock tools provided with the Creality Ender 5. It snaps on to either sides of the Ender 5 and comes in 2 versions: with and without the Creality Ender logo.
It is compact and does not get in the way when handling the printer. Additionally it can be installed and re-positioned without any additional screws, etc.
Simply press it firmly into your desired corner until it clicks. When removing I suggest using a thin piece of metal (the scraper works fine for me) to wedge the clip out of the frame before pulling the holder out.
This is not 100% my creation (it is more of a remix) as I took the PSU tool holder by Pickle_Rick_1 at https://www.thingiverse.com/thing:3026123 and combined it with the Ender 5 tool clip by kilroy01 at https://www.thingiverse.com/thing:3361395. Thank you to both creators for the wonderful models.
Hope this helps and happy printing!
Generic Brand PLA
Most resolutions should work, and the print time for 0.28mm is approx. 2 hours.
Print at 0.12mm for higher resolution of the logo. 0.28mm will significantly decrease the print time and can be used for both the logo and no logo models.
No supports or rafts needed.
I printed this at 20% infill as the clips will be subjected to some degree of stress when installing/removing. I would recommend between 15% - 25% for optimal strength and print time.