A simple tool to remove prints from the printer build plate
I use IRWIN utility blades. They are .025 inch thick (.635mm)
The .STL file has a .65mm gap with tabs to fit the notches on the blade.
There is also a looser version with a .70mm gap.
If it is too loose just insert a piece of paper or cardstock to tighten it up.
2 versions. short(PRT1) & long(PRT2). I mostly use the short one.
I have been using this for months. I thought it was finally time to share.
I also made blade covers, but I usually dont use them.
BRIM may be needed (or maybe not)
designed in Tinkercad