I threw together a really simple Raspberry Pi camera mount for the Y axis motor cover, please remix and improve as much as you like, original design is to not require glue or screws but just be a super fast to fit clip on and go type mount without any support required.
It would be good to tilt the mount back a little in hindsight and there are probably a lot of improvements which can be made but does the job nicely with zero issues
- Added a little optional front cover for this too
I printed at 0.16mm layer height, 80mm/s on ender 3 and its come out nicely
next design will be a replacement Y axis cover with a tiltable camera mount i think but for now this will do nicely