This is a Foxeer Box 2 mount for the HyperLite FlosStyle / FlowRide Frame. I used my Foxeer Box 2 sleeve (found here: https://www.thingiverse.com/thing:3629891) and added the base. It has a 35 degree tilt and is mounted by using longer screws in the front standoffs and a short screw that goes through the rear of the case and top plate then held in place with a nut. I'm using a plastic (nylon) nut in hopes that it would break before the top plate in a bad crash. Please print this in TPU and as it's shown in the render, no support are needed.