This is a clip that can be used with some garden stakes to connect them. When several are used together, they can form a tripod, quadrapod, lattice, etc. for use around plants that need support, such as tomatoes, peppers, etc. The two arms slide into the connector; no snap-together portions are used. Recommend an outdoor-tolerant filament; PLA does not tolerate adverse weather well.
Example print was done in PETG (used 235C end, 85C bed, 40mm travel with retraction, 0.2mm draft quality and 20% infill on an Ender 3).
Created by me, and released under the public domain.
Feel free to message me with any questions.
After printing, slide the ends of the arms into each side of the connector; the connection will be tight and requires a bit of force. In the print, the side of the connector on the print bed's hole is 0.1mm wider to accommodate printing artifact. Glue is not typically needed, but may be used.