After scouring the internet I was unhappy with the options available to purchase clamps needed to make multicore claptons as flat as they should be. I have seen other 3D printed options available but they were for sale, and nothing existed for printing. I modeled these to make life easier and share with everyone to help foster the community of vaping and 3D Printing.
Hardware needed: 5x m3 screws, 5x m3 nuts. Drill. Swivels.
For orienting the print, orient the drill side so the shaft sticks up, the model acts as its own support and you can pull the top section off.
The model was designed with the intention on using a swivel set up. You may also want to use paper clips or something to keep the cores flat along the length, these just keep it level when chucking it up.