This is a fully printable mATX case. Minimalist open air design with optional surface mounting, like a wall for example. NO HDD mount, designed to use m.2 drive. Will accept a full height video cards. Designed with loose tolerances for better results with different printers and materials.
Some assembly and gluing required - Read post printing note
REQUIRES A 300mm x 300mm print surface <<<<<<<<<<<
This case may not fit every configuration, if you wish to have a small modification or have suggestion for improvement, please leave a comment.
In order to successfully print this case, please follow instructions below
-Print each type of corner in both normal and mirror.
-Print the number of standoffs required for your motherboard
-Print 2x long panels, 4x long rails, 2x short rails
-2 front panels are included, one for the popular Corsair SF450 and one universal PSU
Long pieces (long panel and long rail) are designed to be printed diagonally because they exceed 300mm in length.
Rails are designed to press into the corners, the motherboard, PSU tray, IO panel and bottom rails need to be glued (or fused with acetone if using ABS). Top rail can be just pressed in, in order to change out the panel if different color or pattern is desired in the future.
Standoffs should be fastened to motherboard first then glued to the motherboard tray for perfect alignment. Recommend leaving metal IO panel out until standoffs are properly glued to avoid metal IO panel pushing the motherboard away.
Power supply mounting bracket is designed to have maximum strength by avoiding loading the layers of the model. Fold and glue this bracket, then glue to power supply tray.
Cables can be routed under PSU and under motherboard for clean cable management.