Remix of functionaldiyer's glock block... and Anonymous_Nobody's P80 Glock block.
This one is really just a combination of the two, with some rounded edges and an additional hole... That just happens to fit the rear pin on my glock 43 (and probably a 42 then).
I also added a v-slot which ran through a hole on the back, just in case you need to use it on a different gun to knock some pins out.
Should hopefully work with glock frames 1-99 (or whatever theyre up to now), as well as all P80 frames (hopefully). One pictured is the PF940CL (thats the compact, long slide), as well as a glock 43. It might even work with other not glock frames. shrug
Because functionaldiyer had his watermark on his, and this was 90% his design, I figured Id throw it back on there for him. Rather than re-release his work without it.
(of course, any competent user can remove it from the stl in a minute)