Printer Used: Prusa i3 MK3s MMU2s
Firmware: 3.7.0-2201 / 1.0.5-297
Software: Slic3r Prusa Edition 1.41.3+64win
Printer Settings: 0.15 mm Quallity
Filament: Prusament PLA
Printer: Original Prusa i3 MK3s MMU2s
File Type: .STL & .gcode
Additional Hardware Required: Hilitchi M3 Hex Socket Head Cap Screws and Nuts.
6@ M3 Nut
I am using the following filament spool holder in combination with my spool holder stand.
Side note: I am repurposing some of the parts that came with my Prusa printer spool holders to complete this build. See attached images.
This build does not require you to have these repurposed items. You can use one 8mm threaded rod, two 8mm nuts and two 608 bearings. Just remember make sure that the rod extends far enough to compensate for the nuts being placed on the outside of the stand. See link above.
File 1: L-R Side Filament Spool Holder v1_0.15mm_PLA_MK3SMMU2S.gcode
Print Time: 2h 52m 27s
Notes: Make sure to have the print laying flat on its back with the filament spool spacer facing up. Make sure to print 2 of these to complete both side of the spool holder.
File 2: Base Filament Spool Holder v1_0.15mm_PLA_MK3SMMU2S.gcode
Print Time: 4h 55m 54s
Notes: Make sure to have the fillet side facing up when printing.
Grey / Black
Outside view of the filament spool holder.
Outside view of recessed screw holes.
Inside view of the filament spool holder.
Inside view of filament spool holder spacer.
Bottom view of the filament spool holder.
Bottom angle view of the filament spool holder.