This is a edge mount for the CyberPower powerstrip. Two of these mounts slide over the end of the power strip, or can be flexed enough to insert the powerstrip from the front. The other side contains a slot that slides over the side of your desk. The Mount is secured to the desk with 1-2 command strips inside the groove. If you need to have extra security for your power strip you can secure it inside the mount with double sided tape, or command strips.
Desk Edge Width: 16-18 mm
WARNING: Use the .3MF file for printing, if you use the .stl the print will be hundreds of times too small, I do not know why this happens, but as long as you use the .3mf it will work.
Amazon Basics PLA
WARNING: DO NOT USE THE .STL FILE FOR PRINTING
If you are going to make this use the .3mf file, the stl file is too small for printing, it is only here so thingiverse will show the model.