MakerBot Print is our newest print-prepration software, which supports native CAD files and STL assemblies,
allows you to interact with all your printers via the Cloud, and many other exciting new features.
This is a set of walls for use with my MagHex Tile System for Gloomhaven. These walls have magnets and wire nail holes in strategic locations that allow you to securely place them on the MagHex center mag tiles.
There are wall sections to work as both "flat to flat" and "point to point" so you should be able to build every scenario in the book. (Untested)
Want doors for your scenario? Check out MagHex Doors that work with this system.
Three ways to use MagWalls with MagHex Tiles:
Press fit 3x3mm neodymium magnets into slots on the bottom of the wall segments. It's a friction tight fit and requires no glue.
Press #19 x 1/2" Wire Nails into recessed holes on the bottom of the wall segments.
a.(Nail dimensions: 13.5mm long; 2.2mm diameter head; .5mm thick head; 1.1mm diameter shaft)
Glue MagWall segments to MagHex Blank or Terrain tiles.
MagWall sections come in 3 types:
F type - Used on Flat to Flat sections of terrain
P type - Used on Point to Point sections of terrain
C type - Used to link sections together at a corner
MagWalls use 3x3mm neodymium magnets that you can buy in bulk from ali express or ebay.
The polarity of the magnets needs to all face the same direction and match the polarity of the center magnets used in the center mag bases.
The wire nails can be bought in large packs for very little ($1.50) from any home improvement store. (Home Depot, Lowes, Ace, etc.)
Some wire nails will have to be cut shorter so they wont extend out the top of the model.
These walls are under construction! Proceed at your own peril! (hehe)
Test all walls
Make other wall types
Added 3 more Ashlar walls.
Updated the Ashlar wall type with a deeper texture. The test print didn't have enough definition to paint easily.
Added a new type of wall! Ashlar! It's similar to Cobble, only not ruined. There are 8 pieces to try when you're building your next scenario!
Added Forest Grass wall. Print at .4 layer height, 100% infill. Cut away the cylinder. Press magnet in first, then use a blow dryer to shape the strands. Thanks to RobagoN for the idea!
Made 3 new Wood wall segments
Made 11 Stone walls segments! These have a cavern like appearance that looks very similar to the original tile art.
Added 4 Forest themed wall segments. The giant mushroom has to be printed in two parts and then glued together. I want to make more forest themed things, but I'm fresh out of ideas. Please post a comment with suggestions!
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.