This is a small single dosing funnel for the Quamar Q50e and Q50 manual models.
You can move the cap up and down a few times to help blow out most of the remaining grounds.
This reduces retention down to a more managable 0.8-1.0 grams from the quite massive retention of approximately 4 grams that you get with the stock setup.
Just grind through a good gram of fresh coffee if you havent used your grinder for a while and put in your desired amount of coffee. You should pretty mouch get out what you put in.
- Take off your stock bean hopper.
- Place the base of the funnel onto the adjustment ring of the grinder and secure it with the stock screw.
- Insert the funnel into the opening on the base ring and make sure it is down as far as possible and center it.
- Use a drop of superglue to attach the funnel to the base ring.
- Take off the base ring with the attached funnel and apply superglue all the way around the inside seam of the two parts.
- Leave to cure.
- Remount the funnel onto your grinder and enjoy!
doesn't matter PLA
performs best in pink
Use a brim for the funnel part and print it upside down for best results.