Additional materials you need:
M3 nylock nuts ( 6 pcs )
M3 T-Nuts ( 2 pcs )
Couple of M3 screws ( button head ) different length
Two felt furniture pads
A Glue gun recommended
Replace bottom plate
Take your Tronsmart Splash speaker and remove round long rubber pad from the bottom.
Take out four screws and remove the bottom plastic plate. It may be glued a little.
Take those 4 screws and screw printed plate instead. Take a note about rubber cover of USB\TS slot.
Assembly clamps using M3 screw and NyLock nut. Make sure it is moving.
Put a M3 T-Nut into the clamp's rectangle hole, facing narrow side inside the clamp.
Use a crew from another side to ensure it is in place. Close the hole with printed stopblock and put a drop of glue from gluegun to hold it in place. Make sure TNut will never roll over.
Assembly holder and clamps
Assembly holder and clamps. using Nylock nuts. Make sure nuts are facing outside.
Glue felt pads
Glue two felt pads into the holder.
- Mount assembly
Mount assembly to the handlebar, screw the speaker inside, lock it with printed lock.
Rotate mount angle so speaker faces your eyebrows or little bit higher. This makes most sound hits your ears and you can make volume lower.