Check out the slightly more complicated v6.2- https://www.thingiverse.com/thing:3608091
Some refinements based on previous design. Added base and dual paths for stability. Made stairs sturdier. Gave the stairs some space inside so heat gun no longer required, perfect fit :))
Although I will probably extend the stair “walls” because the dice sometimes escapes the tower.
2 hour print, over 90% improvement on previous towers in terms of time.
0% support, but manual assembly is required. Printed as 1 base and 36 stairs (6 sets).
Printed and tested to work as it should :))) accommodates up to 19mm dice :D pretty great for such a small size tower!
If i made a positive impact in your life please support me via paypal :D
Thanks for stopping by, come back soon ;)
Previous Version V6
This was the v6 which i deleted because the v6.1 was such a vast improvement but based in the same design. :)