Careful that you know what type of feet you would like to print as only one will allow of the lower shelf
320x320mm or larger printer needed
Concept - print/modify at your own risk.
I currently do not own a 3D printer and have not used one before so I do not know the capabilities or limitations of a 3D printer
no too;s or screws should be needed as it is designed to tightly slot in to itself
- Can be made as tall as you would like the shelves are 26.5 x 28.5 cm
- Once built the spacing between shelves will be 27.8 cm
- In example images of the shelves, the taller left unit is 93.3 cm Heigh, 34.9 cm wide and 29.1 cm deep
To my understanding and to be taken with a grain of salt. it maybe best to use a higher infill in the side panel/supports but not 100% to allow it to have a small amount of flexibility. This will be needed as the inside will receive more load from the items on the shelves and help reduce materials like Pla from just snapping under pressure.
I welcome all feedback and would really like to see any finish pieces or remixes! :)