The Idea is to put it on top of the Stem below the Topcap to turn on the Lights powered by a Hub Dynamo, hiding the Cable inside the Steerer.
Ground could be put on the Frame and Forks leaving you with 1 single Cable for each Lamp.
The Switch would have to touch the Steerer to turn on the lights.
From this point i have no idea how to pull it off without causing a shortcut
1 1/8 Steerer - 6mm Height
Suggestions Welcome :)
Your Choice PETG, ABS, NYLON (DO NOT USE PLA TO AVOID INJURIES AND/OR DAMAGED PARTS!)
Max. Nozzle size 0.4
Max. Layer 0.12
Higher Temp + Slower Print Speed recommended
Flex Material recommended for the Switch Cap to prevent a loose Switch
Use Extra Walls instead of Infill to make all pieces solid