Hello everyone with a new mount for nema 17 in a old Vixen Super Polaris, frome the gear to pulley, from equatorial mount to go to equatorialo mount.
Used a STM32 board for control with the famuos project OnStep https://groups.io/g/onstep/wiki/home
For the connection there's a place for a standard 9pin connector
Don't need any particulary printing setting, but it need to be hard...I used 3 ext layer, 3 top and bottom layer 30%infill
BOM part list:
2 nema 17 motor
2 gt2 16t
2 gt2 60t
2 gt2 belt 180mm
Some little support are needed in each for the 9pin connector and in the AR in the anvile cause I don't make it with the same profile all the part...