I found similar ones online but did not fit my needs or space requirements. This is just a basic mount for a male XT60 and LED's. This was created for my Micromake D1 as I had replaced the fire prone connector with 10 AWG wire and an XT60.
Sick of just a cable hanging out of the back of the printer.
I just used a little LED strip and some super glue to hold it and the xt60 in place. The xt60 is snug but wanted more than a pressure fit for it.
4x M4 6MM, 4x M4 Tnuts, 4x M4 ID 1mm thick Washers