I designed this faceplate for the Philips Hue Dimmer Switch because I needed such a faceplate and all the other 3D prints similar to this one just didn't fit right or work out the way I wanted them to.
I wanted the overall size and shape to be same as the Lutron screwless wall plate. This allows for a much thicker and stronger design. It is intended to be printed flat on its back. There are cutouts on the back that will need support while printing. Version 1 is where the Philips Hue dimmer switch is on the right of the faceplate and version 2 has it on the left.
When attaching the faceplate to the wall, it is best to use a flathead screw for the top hole located under the dimmer switch. (See in photos). This allows the dimmer switch to set completely into the groove. Two 15x3mm neodymium magnets will fit perfectly into the integrated mounting holes on the back.
If there are any needed improvements with this design, please let me know.
Hatchbox PLA or ABS