Quick Grip Trigger Clamp
This is a fully functional Quick Grip Trigger Clamp. C-Clamps have become very popular prints but the clamp allows quick single hand adjustments. This design was created with fusion 360 and printed on a Prusa i3 MK3.
Everything on this clamp is printed with exception to the springs which make it functional.
Springs can be found in this great spring assortment on amazon:
Springs needed are:
0.035"x0.25"x0.5" for the release trigger
0.041"x0.437"x1.062" for the clamp trigger
The kit has enough springs to make 6+ clamps.
The printed version shown in pictures is printed in three different filaments:
Black parts: https://amzn.to/2Dt6xho
Ziro Carbon Fiber PLA (One of my favorites to use)
Grey parts: https://amzn.to/2DqNS5J
Prusament Galaxy Silver PLA
Orange parts: https://amzn.to/2VXMHSm
Amazon Basics PETG
Clamp Body & Clamp End
These pieces can be printed together with supports. If printing 1 at a time Clamp end doesn't need supports most likely but does need a brim.
This piece should be printed vertically and upside down. The circular pivot part should be on the print bed.
Release Trigger, Clamp Bracket & Shaft
These pieces can all be printed together (depending on material preference). Shaft and Clamp Bracket laying flat and trigger release on edge.
Grip needs to be duplicated. Print 2x together.
Assemble parts as seen in pictures.
Insert springs in areas shown in pictures.