E3DV6 mount with dual radial fans for the Tronxy X5S series of printers.
This will only fit if your X-axis plate looks like the one in the picture.
The distance between the outer two holes must be approximately 58mm.
I've included versions with provisions for mounting an endstop. I have not tested those files, since I no longer use endstops for X and Y, but it should fit.
Printed parts you'll need:
Whichever fan ducts you want
2x M3x10 or similar for mounting the extruder mount to the metal plate
2x M3x20 plus nuts for clamping the extruder down
1x M3x20 plus a nut for every 5015 fan you wish to use.
The fans are height adjustable. I advise to use a little M3 size washer under the screws which hold the ducts to spread out the force a bit more.
I may tweak the ducts in the future for better air flow - currently, on full power, they cool down the heat block significantly due to the air being redirected up.
I recommend always using a silicone sock on the heater block to prevent heat loss from fans.
With the E3DV6, you definitely need a silicone sock for the heater.
Anything past 40% fan PWM resulted in my nozzle cooling down enough to make the extruder skip.