Another Keepsake box, this time with a lid having a lip seal instead of locating pins.
Like my other one, be sure you have excellent bed adhesion because the sharp corners tend to lift off of the bed surface otherwise.
Use supports "touching the build plate" for the box, they should appear only at the bottom where the first bead extends from the base; they are very easy to remove.
No supports are necessary for the lid, as long as it is printed with the seal upward, but the same bed adhesion tip applies. This lid is tight by design, so a little sanding will be necessary if you want it to be looser.
Amazon Basics ABS
Supports "touching the bed" for the box only; the lid doesn't need them, but a brim is recommended for both.