wanted to build smoother in the E12, so veni vedi vici
For the Mosfet-Smoother you need 6 (8) flat head screws M3x6mm,
leave 2 holes at the Smoother. As well as 2 pieces each washer
DIN 9021 M4 with nut, for fixing.
For the smoother holder you need
8 (16) pieces of flat head screw M3x6, two holes both smoother each free
(reserve). For fixing to the housing 3 pieces flat head screw M3x8 with
washer DIN 9021.
Remove the three cable sockets on the back. Note where which plugs were !!!
Assembly of the mosfet smoother:
- remove all obstructive, unscrew the power socket. Loosen the rear fan
and twist it so that the cable comes out of the lid, where the Mosfet
holder has a cable guide. Replace the screws on the fan with flat head screws
or leave them near the cover.
- Pre-assemble the Mosfet and smoother onto the carrier, place the carrier
on the screws of the filament carrier while fixing the fan cable. Put the
slices and carefully tighten the nuts. This smoother is for the extruder exit,
is not really needed, but had 5 pieces.
Assembly of the smoother carrier:
- Hold the Smoother carrier on the outside and mark the ventilation slots,
for 3 holes, 2.0mm diameter.Insert bores and provide all holes with 3mm thread,
Screw in carefully enough. Pre-assemble Smoother on the carrier
(2 flat head screws each). Since the cable length of the smoother is only 10 cm,
the carrier should rest against the rear wall (spacers with cable routing
are present on the carrier).
The front smoother it for the X-axis, then comes Y-axis, Z1 and Z2 at the very back.
- Mount support with the 3 flat head screw M3x8 and washer DIN 9021.
Reinstall all cables and connections, with stepper motors now with smoother in between.
It's pretty tight. Carefully reinsert the power supply and close the bottom.
It is a very sensitive work, sorry for fat fingers and hotheads.
So I wish a lot of fun and endurance.
Enjoy the new printer noise.