A tool holder to attach to the Harbor Freight magnetic tool holder.
I wanted a toolbox that I could use with the magnetic tool holder I purchased which I attached to the 3D printer stand I converted from a Walmart end table.
I used a slot cover taken from a computer case I had built in the past. I had been holding on to these in a box for years and finally found a perfect use for them.
I used a Dremel to cut the slot cover close to the top and then used super glue to attach to the box. It is strong enough to hold some of the tools I use regularly when I print. There is a small indent designed on the back to allow the metal bracket to be flush to the back of the toolbox.
Use a cutting tool to cut a metal strip to attach to the back of the box. The design was created to leverage the expansion slot covers found in many computer cases that are usually thrown out during PC builds.