This attachment clip is designed to be simple and generic. The intention is to add flat surface on the back of the 2040 frame (Above or below the power supply) on which you can glue whatever you desire as long it has flat surface.
Most of the clips on thingiverse has functuality of some sort which makes them higher or without flat surface which is suitable for gluing any other add-on such as Buck Converter box.
Adding the clips to the Add-on itself make it harder to print so I prefer a stand alone generic clip separated from the add-on and than glue them together.
There are 2 versions:
Shorter 10mm length clip - in case you would like to add 2 short clips at the edges of the glued object.
- Longer 20mm length clip - in case you would like to use single clip at the middle of the glued object.
I really liked the following Buck Converter Box:
If you would like to support me - you can purchase buck converter from the following affiliate link:
XL4015 5A DC-DC Step Down Adjustable Power Supply Module Buck Converter
Recommended printing orientation is upright with Brim (As seen in the pictures).
I printed with 30% infill however it is quite thin so at can be upped to 100% without to much filament added. Bed on 60C and hot-end on 200C. speed depends on you fans configuration.