After tailchop the monster needed new Tail Light assembly. I had this led strip (E-marked) 127mm x 8mm x 10mm. So I modded millenium falcon model to suit my needs :)
The result is not 100% symmetrica, but It is hard to notice without close inspection.
You need to add some mounting structure to get it in place. I added aluminum plate with some heat. Also used Hot glue. Also You might need to cut a bit from the key side, because there is this metallic tube for the seat opening wire.
The Led strip similar to this: https://www.louis.eu/artikel/highsider-led-tail/10033128
Things to fix:
- The whole thing needs to be a bit wider
- I need to make it more symmetrical
- Mounting holes
XYZ Tough PLA
Printed with Jr. 1 (no pro)