This is my first glider, it is flying quite stable but needs some improve which i will add later after some more modifications and tests.
The fuselage is common and you will find in other gliders, futures one will be different.
the back stabiliser needs to be glued and once done that its ready to fly.
I will add an back holder, in the future design, as it is a bit hard to lunch without bending the stabiliser.
I used PLA which is more than fine as is light and the entire plane weight approximately 14 gr.
The printed plane in the pictures is dirty as it was landing on ground in my garden.
I hope you enjoy this design and click on like or support to boost me as is spent a bit of time and few calculations doing that
Any brand, PLA or PETG,
Any visible color
I use white one but is not visible in the garden, I suggest a visible color as green or red.