This paper towel and napkin holder separates into the 6 pieces listed below.
1 Napkin Holder/ base
1 Paper towel pipe mid-section
1 Paper towel pipe top
1 Castle/ base
1 Flag brick
The Flag brick belongs at the bottom of the flag pole.
The dimensions are approximately 16.875 inches across, 6.25 inches deep, and 12 inches tall. The paper towel and napkin holder breaks into many pieces for easy printing. When creating this I did pay attention to the part tolerances so they should all fit together as planned.
I would recommend printing this with a low infill amount, this is large and will use a significant amount of filament.
I hope you like this.
Green, Brown, White
I have not printed this yet; however, the information above will likely produce accurate and satisfactory prints. A higher resolution may cause interference with the parts.