A customizable Rocket Display Stand for motor sizes up to 38mm, but light 38mm rockets. The leg sizes are adjustable to allow for more stability on heaver rockets. Better for the Estes, Quest or Apogee style models.
Have to thank a club member, Pierre, for bringing in one of DJKingsley's designs which sparked the scad creation to adjust the motor tube sizes
Any PLA, PETG, ABS
The layers should be well fused with heavier rockets (higher temps), since the layers are the weak point with a raised centre mount tube.
Make the top and bottom layer thickness 1/2 the base thickness to make sure the legs are solid (no infill), again helps with heavier rockets. Does not mater much for the light ones.
If the centre tube is raised you will need supports so select this with your slicer of choice.