I modeled this after the remix listed but this thing was designed from scratch.Most of the cyclones have a side inlet. This one angles down then off to the side at an angle and from the videos of the remix it seems to work pretty well that way. I havent tested mine yet. The hose connections are about 30mm or about the same size as a small shop vac hose. I may add some adapters later. I did add a warning on the front for the absolute chaos going on inside this thing! lol
update: added another cone with a smaller outlet. I read somewhere that this could possibly make the unit more efficient. I will leave both cones on here for download.
update: added thickness to small cone threads
This is meant to be printed solid and you must use supports. Use atleast 3mm walls and the void in the piece that says cyclone on it will end up with support material inside of it but this wont hurt a thing. I added structural support pieces for strength inside of the void as well. This was all done in an effort to conserve filament. All of the angles and support in that piece already coupled with 2.5mm thickness makes it more than strong enough for the job intended.