This is my custom design for a D&D hero / dice / pencil vault I've created as a birthday present for my best friend. A best-of-design combined out of all solutions out there (for me at least).
It can keep safe:
- 1 Pencil
- 2 Miniatures
- 7 Dice
I've printed this with a JANBEX Wood PLA.
It took me exactly 48 hours to print this with my settings (see below).
After printing I've sanded it with 320 sanding paper.
Then I've stained it with some english oak water stain.
I've added multiple layers and let each layer dry properly before adding the next.
For the D&D logo I've also added some army painter strong tone wash to get it even more darker than the rest of the surface.
The holes are designed for 5x5x5mm neodym super magnets that I've inserted with superglue.
At last I've inserted a 5mm layer of acoustic foam on each half of the vault also with a little bit of superglue.
(I've got all materials from Amazon. So it shouldn't be that hard to get them)
UPDATE - 2019-04-15:
I've made another one for my other friend's birthday in dark green (which turns out it has a slight blue tone).
UPDATE - 2019-04-18:
Added a blank version (without D&D logo) of the top part.
UPDATE - 2019-05-23:
A little update just to tell you that I've created 4 pieces of this now in the meantime and one looks nicer than the other!
Hope you also get nice results! :)
You should flip the bottom piece 180 degrees so that both pieces will be printed with their holes on the bottom.