UPDATE - New File Added - "C Mount Camera Case Front Revision A.stl"
Identical to "C Mount Camera Case Front.stl" but with slightly larger screw
holes to make it easier to cut-in the M3 threads, and a slightly larger lens-
mount through-hole to avoid damaging the ribbon cable when the front is
snapped over the lens mount.
This case was designed for the Arducam OV5647 camera module which is equipped with a CS-Mount lens.
Supports are only required for the screw head countersink holes, and no brim or skirt is necessary if your printer has good bed adhesion.
It requires four M3x8 screws to assemble, and I recommend that the screw bosses be acetone-hardened and then carefully cut threads with an edge-ground screw as I made these very tight in order to clamp the shells together securely.
It has no mount for a camera arm, since so many exist and it is a simple matter to mesh-mix the desired one to the camera shell, or cut one from an existing arm and bond it to the C-Mount shell.
The opening for the lens is tight by design, so be careful not to damage your ribbon cable when snapping the case around the lens base. The lens itself does not have to be removed to fit the case front, but the locking screws must be taken out and replaced afterward.
Amazon Basics ABS