This is a custom holder for a T8 8mm Lead 2mm Pitch T Thread POM Trapezoidal Screw Nut Seat for the original HyperCube by Tech2C.
It is meant to be a simple and semi-permanent holder for a T threaded anti backlash seat (makes wonders to Z-wobble compared to a regular trapezoidal screw)
Things you will need:
1x T8 8mm Lead 2mm Pitch T Thread POM Trapezoidal Screw Nut Seat (I used this one from Banggood: https://www.banggood.com/T8-8mm-Lead-2mm-Pitch-T-Thread-POM-Trapezoidal-Screw-Nut-Seat-For-3D-Printer-p-1167104.html?rmmds=myorder&cur_warehouse=CN
2x M3x45mm screws (I use hex, but phillips would work just as well)
2x M3x30 Phillips screws
4x M3 nuts
2x M3 washers
1x M5x15mm screw (because the nut seat from Banggood does not include this)
Why did I make this? I try to avoid using T-slot nuts as much as possible (the cheap ones rarely fit very well and my 20x20 extrusions from Europe most certainly does not...) Also once I have tried fitting everything I like to make it more permanent so I usually drill through the extrusions, hence this is based on M3 hardware and requires you to drill two holes.
PrimaSelect PLA or PETG
PLA works (use a lot of infill) otherwise print in PETG or ABS