This is replacement plate for Bosch GTS 10 XC table saw. It fit's in the place of the original one.
This one is better because it's much easier to turn off the saw - so it's safety feature. You can do it both, by pushing down or to the saw on the bottom part. Or you can pull upper part.
Best part is, you no longer need to bend the knee - to turn off the saw! (With sled on the saw and such a small off switch I always had to look for it by eye first and then push it. Sadly this required to bend a bit :D ).
You can start the saw, like before, by lifting plate or use new additional window - so you can just push start.
Because of the fence rest location, this plate cannot be extended down easily (to push it with kick) - so this is the best shape I could figure out, with many tries and errors.
My other shop upgrades: https://www.thingiverse.com/Saur0n/collections/sshop-general
does not metter Any stiff - PLA is ok
Support is needed to print upper shaft holder. Window is fully printable with bridging. Rest does not require supports.
You can fill "STOP" letters with red, thick paint. Use needle or something pointy, to drop paint drops. Before that, you may want to spray paint it to prevent colour bleeding between layers.