Want a super accurate Hammershot? Want more shots out of your Hammershot? Want it minimized with the option of adding a bottom picatinny accessory? Yep I did too. I made this Hammershot kit to cover all those things from remixes of other peoples amazing work. I call it the Bustershot (kit).
**SHELL CUTTING IS REQUIRED for both adding a bottom rail and/or shortening/minimizing the front end.
7 SHOT CYLINDERS
Originally only made a brass remix orginally from eightbitbuenos, but I know not everyone can easily source brass so remixed the orginal 7shot from Horseengineer. I recommend the Brass > non-FVJ version. If you decide to brass it, you'll need to cut out seven ~27mm pieces. One foot of K&S 17/32 will be more than enough.
Pictures show where you would need to cut for bottom rail, basically the whole orange section; keeping the gray areas. After confirming a good fit and centered alignment, slip it on and use some super glue to attach it to one half of the shell. This should help the rail not move.
FRONT END MINIMIZATION
Minimization will require you to print the front end out. You will have to mark where the edge is on the shell. Also mark the front of the top attachment spring rest box. you will need to cut and remove the section in between these two marks, see photos. I recommend removing all internals and putting the shell back together then cutting them at the same time. A bandsaw will help with straight cuts here.
Keep the two gray pieces and two orange pieces from the very front. I just used super glue to attach them back on to the shell. Add some hot glue or plumbers putty inside the gaps if you want to be extra safe.
You will also need to remove the two small support pegs/angles under the spring rest box thing for the top nerf rail attachment so that its flush on the underside.
Also included is a remix of the reinforced Hammershot hammer. I noticed it prints out a leftover hole where the peg is so I removed it. Also rounded over the front end of the hammer because its a bit sharp with the 90degree corners.
Also included are Horseengineer's 7dart Spinners.