NOTE: The original Taco I posted is wider and taller to fit an RC chassis. I printed it and didn't like the tall dimensions so I've done this one.
This one is exacting to an actual tacoma when viewed from the side but wider to fit the RC chassis. I prefer it. It is a 313mm wheelbase.(AxialSCX10) and it is 190mm wide at the bottom of the doors. Same as the Proline Chevy C10 body.
This has also been cut up with printing and minimal support in mind. I also put the windows in because it is so much easier tp print. I plan to cut them out or paint them gloss black. It printed really well for me.
NOTE: A few people have asked about the Axial Wraith. My math says that if you print out each piece at 1.13 or 113% it will have a wheelbase of 353 and a width at the wheel flares of 250mm.
• Don't forget to like, comment, follow and post makes. That's the gas.