Two versions of the Flexi dragon
- One with support but in one part
- The other with no support, but have to glue two parts together
Stronger and error free Remix of the flexi dragon with two wings. (https://www.thingiverse.com/thing:2905736)
Print it with supports : everywhere, lines, at 45 degrees.
With cura I advice oneto observe carefully layers around the support in order to check if all is ok.
There are some few artefacts but supports must NOT block the flex structure.
Edit : I spend 2 hours for this model from the orginal one. And now I can see that in fact, the author had already made one (larger)....
Note : I did not print the current version with ihas stronger links. But it should print well.
I've just printed the two last element of the tail to check, and yes, it is a lot stronger.
Edit : I've splitted one of the two wings for better result and no support at all.
Not printed also, but I don't see why it would fail. Glue them together with acetone if you print this with ABS.