Pop up clover shaped basket. Print in place, can be used as trivet when flat or as a basket when popped up.
Note: This is a very precise print and will only successfully print on well calibrated printers and close following of directions.
Important, must slice at exactly 0.25mm. There is a gap in the model that has to be exactly that height or either the rings will either fuse with the base or will droop too much. Also preview the gcode before printing to make sure you have that gap layer, reference the screen shot.
After printing the model will be lightly fused together. I took my print removal spatula and starting at the handle worked the ring and spiral from the base. Go slowly and don't use too much force or you may snap base completely off.