A fully 3D printed infinity cube with the option to place a logo on a post to repeat forever.
Plenty of tutorials for these online for making them from timber, but not many where the frame can be 3D printed for maximum convenience.
A full guide to assembly and wiring/programming the neopixels in Arduino can be found here: https://youtu.be/O66MMnKqNQ0
white and black
4 x posts and 2 x end pieces, one of each for the rest.
No support needed. Only chance you'll need a raft is the four posts.
Full assembly in the video. You may wish to clean up the holes in the end and cap pieces with a 3mm drill bit, and a 2.5mm drill bit for the posts and inner electronics housing holes.
8 x M3 x >=20mm plus 4 x M3 x 16mm bolts are needed for assembly.
Six 2 way mirror tiles are required. They should be squares with an edge length of 100 - 102 mm. Thickness should be 3mm or 1/8 inch.
I needed two 23 LED Neopixel strips to correctly match the inner circumference of the end pieces. Please trial and cut the correct amount for you depending on your LED strip.