Just a simple LED tape bracket for the standard 10mm wide 24v led tape.
This hooks under the lip at the front top of the frame and lets you slide in 30mm of LED tape.
All you need to do then is attach some wire to your LED tape and connect it to one of the spare 24v output and ground terminals on the internal power supply, Voila, bed lighting.
The piece has such a small footprint I had issues getting it to stay attached for the entire height, so I designed a model which has a large flat base and the two sections required placed 0.4mm apart so that they use each other for support.
You need to remove the base and separate the part. The base should just snap off due to the way its designed. Run a sharp knife down the back side of the two parts (the side without any webbing to hold it together), then they should separate with a little force.
I personally found that the footprint is too small to support the print when it gets taller. I printed with a raft to help alleviate this issue.