Hey, here's a 1/30 scale Zlin 242L, ready to print.
[Edit v.1.1. Updated cowling to more accurate profile w/ stall rails, improved prop shape, thinned landing gear legs, and changed recommended print settings for rear fuselage.]
Printer settings for Cura Ender 3 profile set to “Fine” for all settings with the changes below made:
All components 0.1 layer height except:
Ailerons, rear fuselage, horizontal stab 0.15
Nose wheel, main wheels, nose oleo, landing legs 0.06
Wall thickness 2 for forward fuselage, cowling (use 3 walls)
Wall thickness for Rear fuselage single wall to keep tail light. With previous settings coins in cowling would be insufficient to keep the nose down.
Infill 10% for all components except:
Cowl - 20% infill for increased nose weight
Rear fuselage - 5% infill
Prop blades - 0% infill
Brims for all small components for stability, supports everywhere where recommended by Cura.
Print speeds should be the default “Fine” settings for all components (60mm/s) except prop blades, which should be 10mm/s or less.
All parts should be printed individually for maximum quality.
Estimated Print Times:
Forward Fuselage 7h 33m
Rear Fuselage 2h 45m
Cowling 2h 2m
Wings (x2) 2h 54m
Elevator 2h 45m
Ailerons + Flaps (x4) 45m
Vert Stabilizer 1h 16m
Horiz Stabilizer 2h 2m
Main Wheels (x2) 20m
Nose Wheel 15m
Landing Gear Legs 18m
Wingtips (x2) 28m
Rudder 1h 30m
Prop Blades (x3) 18m
Parts may have to be resized x1000 depending on Cura settings.
Enjoy, and please don't sell or redistribute this model without prior permission.