Connector to mount a DJI Osmo Pocket camera to a pole. Painters pole, broom handle, etc. Useful for getting shots above the heads in a crowd, or to "fly" the osmo pocket to simulate shots from a drone or camera crane.
Set the OSMO Pocket to tilt locked mode and have fun flying!
Model has an opening for the USB C connector on the bottom so you can use an external power bank and a small opening to not cover the microphone on the lower front edge of the camera.
I have uploaded two versions.. the one ending with a "-" in the file name has the cutout for the osmo pocket a tiny bit smaller than the one with the "+". In my opinion and with my printer the "+" is just fine. But, if you think the camera is not secure enough, print the one with the "-". On my printer that one grips is very tightly but might cause scratches on your osmo.
I am working on another version that will use a GOPRO style hinge to alow positioning the camera at different angles however, it is really not needed. The Osmo does an amazing job in tilt locked mode no matter what the angle of the "pole" is.
Amazon Basics PLA PLA
No need for supports. Prints with standard settings.