03-19 Added file called BIG-NUTS. Same mount only the holes for the nuts are 6 mm wide x 2.8 mm deep. If you are having trouble with over extrusion and have trouble getting the nuts to fit give this file a try.
Mount file V3 should work for everyone. Adjusted clearances and added strain relief.
Factory sensor will work with file from my other mount. Use only top bolt hole. Bottom may need a trim if its not a snug fit to the mount. I have not tested to see if it is on the bed for mesh measuring
Bltouch file is included and tested with stock firmware/tiny machine firmware for mesh leveling and all points hit bed.
Fan adapter to use the stock 4020 24volt blower fan in place of creality fan.
Printed first set of files and everything went together fine. Some updates to files to come.