I made a little snap on cable holder for the Z cables. This is tested for the Creality Ender 3.
All you need is a fastener. No screws or nuts!
Suggestions or ideas are welcome, just leave a comment. ;)
Visit my website:
Find me on:
If you like this model, please post your make.
If you love it, buy me a coffee!
I like to print pretty strong, those are my settings on a 0.4mm nozzle:
Wall Thickness: 1.6mm (4 walls)
Top/Bottom Thickness: 1.6mm (16 layers)
Top/Bottom Pattern: Concentric (This helps with the small walls on the snap on mechanism.)
Infill Density: 30%
Infill Pattern: Cubic
Infill Layer Thickness: 0.2mm
The most important setting for me was the "Top/Bottom Pattern: Concentric".
I used Cura for slicing.