These STLs make up a set of boxes for the ADIMlab electronics that mount magnetically underneath the printer.
You will need 4 of the magnet brackets and one of everything else.
8x magnets, stronger = better, I used flat, disc shaped, neodymium magnets approx 32mm in diameter. Got them off amazon
4x M4 bolts 60mm long (you could probably find some a little shorter but they have to be longer than 52mm to work well)
4x M4 nuts
10x M4 bolts 8mm long
10x M4 t-nuts
All other hardware came from the original control box, I just used what fit.
YOU HAVE TO INSULATE THE HEAT BED FOR THIS TO WORK. If you don't the PSU and MOBO fans will blow on the heatbed and cause it to cool down, resulting in bed thermal runaway. I just used a cork tile as suggested by other ADIMlab users.
Also when you glue the magnets into place make sure the polarities are not opposing or they will just push each other away and these boxes wont mount properly.
Please forgive the angles of the photos, the printer was going full steam on a clone helmet when I took them and Im not about to mess that up.