This is a multi-part ceiling mounting system for a quadruple sensor setup for the Oculus Rift.
Still WIP. Will upload photos and more diagrams when complete.
Each track mounting block is supposed to be mounted on the ceiling with 3M Command Strips. Zip tie notches fit 2.6mm width zip ties.
Extension Cables for Oculus Rift
This mounting system is designed to extend two of the four Oculus sensors. The central mounting block is designed to fit two of CableCreation USB 3.0 Extension Cable (https://amzn.to/2X5C7K2).
The quadruple cable track (Part C) and the hexa cable manifold (Part F) is designed to fit two of the USB 3.0 Extension Cables above, the Cable Matters USB 3.0 Extension Cable (https://amzn.to/2TN8lI5), and the AmazonBasics High-Speed HDMI Extension Cable (https://amzn.to/2X4upzW).
Some parts are tiny so if printing with PLA, use raft or a lots of glue stick (depending on your printer) to make sure bed adhesion is good, or else they will warp.