V4 dice tower, lime like lol
Finished the base and put 14 slots for micro sd’s in there. The cover also can be used as a dice stopper as seen in the picture.
CURRENTLY UNTESTED, will print soon but not 100% sure about size.
UPDATE: Currently printing, micro sd seems to fit great. Only thing left to test is if cover goes over it just as well ;D will update after it finishes.
UPDATE!!!!!!! I MADE BOOBOO :0 my 16mm dice is too big for the gates (see past pic) Need to increase scale to work. But if i increase scale the micro sd card slots will be too big. After i finish the print i will measure everythijg accurately and updates the model as necessary.
DO NOT PRINT (unless your dice is 12mm or less), wait for my update in the next few days.
I made a 12mm dice in case you already printed before i made changes- https://www.thingiverse.com/thing:3433712
I also added the stl to this make just in case ;0
UPDATE: 20% done and one step almost finished. guess what? :D NO OVERHANG!!!!! YAAAAAAAAAAAAAAAAAAAA!!!!! XD hard work pays off. now to fix that scaling...
UPDATE: 5am and 35% done so i shall be going to bed :) its coming out GREEEEEAT :D althpugh i am slightly worried that the steps might be too far apart? Dice might get stuck. I guess wel see what happens...
UPDATE: 12 hour print :D slicer lied said it was 17, im not pissed lol. https://www.thingiverse.com/make:613268 still need the lid and 12mm dice, ill start that right now.
UPDATE: printed dice and lid, turned out cool :D however.... :/// the 12mm dice gets stuck in the stairs quite often since it was meant for 16mm dice. So i will have to do some work on this. Meaning probably v5 :0
In retrospect, instead of sd slots i should have made dice slots xP i just printed an sd holder before this and i guess it was in my head :0 sowy lol
If I’ve made a positive impact in your life please support me via Paypal ;)