This is my take on a movement tray / storage solution. One tray will hold 5 miniatures on the standard GW 25mm bases as long as the miniature is less than 45mm tall. The goal with this version was to be as compact as possible fitting 10 models in the same space as 4 using pick and pluck foam, all while keeping them safe from bashing into one another.
I have redesigned this set so that no magnets are required and only the base that the lid clips onto requires printing with supports.
I have tried to make sure that the lid does not need to have supports in order to print.
Amazon Basic PLA
Make sure to print the Lid upside down, it's the only item not already orientated. All 4 parts will print on the bed at once
Make sure to use supports on the 25mm Base that the lid clips into, this is to keep the clips that hold the tray in place from drooping during printing.
No supports are needed for any of the other pieces.
I have also included a "chopped" version of the lid in case you don't need the lid but want the retaining clip