DISCLAIMER: i just recognized that i had one of my beam-model of the tronxy at a wrong length. The consequence is that this mod cuts off about 20mm of the printbed!
I'll be looking into this!
This is my current hotend setup for my Tronxy X1.
I wanted to have a partcooling fan that doesnt block the view of the hotend as well as allows for good airflow with as few sharp corners as possible.
I hope you like my version and i will gladly take any feedback to improve it.
I printed the partcooling fan with support only from bed. The removal took a bit of time but was pretty effortless in the end. I also rounded off the corners with a file.