This is a large collection of 31 earring sets for you to print and wear or give away. With Valentine's Day approaching, I’m sure you can find a few good reasons to print a bunch.
Each STL contains symmetric left and right earrings. Each is 30-40mm in diameter and 2mm thick. Those parameters can be tweaked using your slicer. Some styles may be better suited for a 0.25mm or 0.2mm nozzles, but most will print just fine at 0.4mm.
For best results, my advice is to run a bit hotter and a lot slower, but that would be largely dependent on your printer, so use your best judgment.
Give them a try and let me know what you think. I enjoyed making these and I hope you enjoy printing them.
Take a look here or here for additional things you may find interesting.
If you like my work, likes and tips are appreciated.
Thank you for your interest.